How To Repair A Solder Joint
Terry
The Plumbing Sorcerer
- #2
There isn't anything you put over the fittings, information technology's what is inside.
Did you employ flux on the pipe?
To solder, you need make clean pipage, pipe cleaner (flux) and fifty-fifty rut.
If the oestrus on the fitting and pipe is uneven, the solder will not flow all the way around.
Concluding edited:
Terry
The Plumbing Sorcerer
- #4
If you accept not added h2o yet, I would consider reheating joints that look bad. You can check around the fittings to run into if the solder is beaded there.
If you take added water, the fitting will need to exist removed and the procedure started over once again.
Last edited:
- #6
Oatey tinning flux
Oatey tinning flux in the plastic dark-green jar is the absolute best for beginners...
and everyone at whatsoever level
Its water soluble and also completely tins the whole joint for you lot......
I have soldered for forty years and don't really need to utilize it, merely I still practice
because information technology definitely gives y'all an extra "edje" and yous absolutely know
you aren't going to take any leaks. whatsoever.
Last edited by a moderator:
Terry
The Plumbing Wizard
- #x
Just put the flame on the fitting.
I continue a water spray bottle handy.
i) I can cool the fitting quicker later on information technology's been soldered.
2) I can wet downward the woods or drywall earlier I solder
iii) Helps to put out pocket-size fires
4) I can cool off my burning hands when I forget how hot that affair is or if I find there is a hole in my glove when I wipe the pipage and plumbing equipment down later .
past the mode, I don't get the pipe moisture before I solder, only subsequently they've "been" soldered.
If water hurt pipes after they accept been soldered, we would be in serious trouble. They are h2o lines, right?
Last edited:
Terry
The Plumbing Wizard
- #17
You tin ever cut the department out and start over.
Any water in the pipe will forbid "fifty-fifty" heating and prevent the fittings from being removed.
Terry
The Plumbing Magician
- #19
I just saw this in their March issue.
I like how they say "If it all the same leaks, yous'll have to disassemble and resolder. "
No plumber would bother doing information technology this way. Near of the time there is no solder in a part of the joint, and that'south why it was leaking in the offset place.
Save yourself time, by removing the bad joint, sanding, fluxing and soldering with new solder.
You can't heat up a bad articulation and expect expert things from it.
How To Repair A Solder Joint,
Source: https://terrylove.com/forums/index.php?threads%2Fhow-to-fix-bad-solder-joints.1684%2F
Posted by: adelmananympalee.blogspot.com
0 Response to "How To Repair A Solder Joint"
Post a Comment